What is an ARC Fault?
An ARC FAULT is an unintentional electrical discharge- a problem that even the most safety - conscious homeowner canīt always avoid. Thatīs because arc faults are usually caused by undetected problems: Damaged extension cords. Improperly installed receptacles, electrical cable pierced by picture-hanging nails.
|
Why is an arc fault dangerous?
An arc fault may ignite combustible materials and cause a fire- a threat to any home and its occupants. Furnaces in attics are a common problem.
|
What can I do to prevent arc faults?
You canīt prevent arc faults from occurring. However, there is a device that can stop them -- by interrupting the electrical current before any damage is done. Itīs called the General Electric Arc Fault Circuit Interrupter (AFCI), and it electronically detects any arc fault and stops the flow of electricity in a fraction of a second. No electricity, no heat, no fire. And, by tripping on a specific circuit, the GE AFCI helps you identify the source of the problem right at the load center.
|
What causes a power loss?
A POWER LOSS may be caused by a winter storm, and energy shortage, a summer brownout, a downed tree falling on a power line - any unforeseen event that cuts off the power to your electrical system.
|
How can I prepare for this type of occurance?
You can install a backup power system, consisting of a generator connected to a generator panel. We will gladly advise you in this matter.
|
How does a generator work?
When the power goes out, a generator creates electrical power without using a utilityīs electrical source. Typical, a generator is run on fuel, like natural gas or LPG.
When a generator is installed in your home, one main breaker is connected to your homeīs load center and the other main breaker is connected to your generator. The generator panel is then connected to circuits for critical electrical loads - furnace, refrigerator, lights, sump pump, etc. - that you designate need to remain on during a power loss.
|
|
